This will make the contact point and bolted foam latex molds stronger and resistant to pulling out of the insert a bit. I then drill a hole where the bolt that holds the core in will go. To do this, foam latex molds I brush a little wax onto the bolt just to ease the removal and tighten the T-nut onto it. Finally, the last stage is a slow speed where you add in a gelling agent that will cause the foamed latex to congeal. The amount of this additive and variations on the time of the first few stages will help predict the amount of time you have to get the foam injected into your mold.
The Zoidberg Project, Part 10: Mold Finishing and Foam Latex
Once this is all mixed and injected into the mold, it needs to be baked. Sign Up Now. Once that has gelled, the foam in the mold should have gelled as well. After curing and allowing sufficient time for the molds to cool down, remove the foam from the mold and wash.
Hello! My name is Socorro. I have 32 yo. I love dirty talks. My favorit is Shemale, Slut porn, Redhead, Deepthroat
Wanna talk dirty?
With a little bit of glass cloth and some epoxamite, I thread it in between the teeth of the T-nut and tap it down. Latex wears well but will tear under strain. This was later taken over by Alcone.